Fit Vehicles:
For 2003-2011 Honda Element 2.4L
Features:
- Extensively Tested During Manufacture to Guarantee Quality and Reliability
-
Supplied With a Factory-Fitted Connector for Easy Installation
-
Precision manufactured with a sensing element incorporating premier technical ceramics
Where are my oxygen sensors located
Diagnostic Trouble Codes (DTC)
When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.
How to replace an oxygen sensor
1- Disconnect the battery.
2- Locate the sensor connector by following its wires. Disconnect it.
3- Remove the sensor cable from its clips all along its way to the sensor.
4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.
5- Remove the sensor and fit the new one.
6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.
7- Reconnect the battery and wait 5 minutes before starting the engine.
Please take a video clip of the voltmeter and contact us if our sensor:
Goes above range between 0.1 and 0.9 volt
Remains below 0.5 volts
Stays fixed at a particular voltage
You’re free to choose replacement or refund if our sensor fails to work, in this case.
